I2C Keypad Front Panel for 16x2 LCD Display

I2C Keypad Front Panel for 16x2 LCD Display
I2C Keypad Front Panel for 16x2 LCD Display
Product Code: BV4243
Availability: Out Of Stock
Price: £8.00

Available Options


BV4243:

Qty:  
   - OR -   

Stock is available at the new store.

I2C Microcontroller User Interface - Front Pack

This is an LCD front pack that also has a 16 way touch pad, keypad. It is designed for a standard 16x2 display and both the display and touch pad can be controlled via an I2C interface. In addition it has a beeper output so it is a complete user interface. Arduino and Raspberry Pi libraries available, see downloads link below.

This is supplied normally WITHOUT the display, it will take any standard 16x2 display including the newer RGB types.

top anotated image top anotated image

It is normally supplied without an LCD so that one can be fitted. There are 18 pins and so an RGB back light display can be used:

top anotated image top anotated image top anotated image

top anotated image

Any 16x2 display can be mounted to the device quite easily, if a standard single back light display is being used then the two extra pins can be removed (cut)

top anotated image

Fitted with a standard low cost blue display.

online icon Data sheet and resources

Description

Each touch pad consist of two capacitive touch channels and a key is determined as being pressed when both channels are activated. All of this is decoded internally so the host is presented with a simple key value.

For ease of use the keypad will buffer keys so they can be read at a later time by the host microcontroller.

The front of the PCB is designed so that a vinyl or similar overlay can be stuck to it thus the pads can be designed for the application in mind. Several pads can be grouped to make one larger pad if required.

top anotated image Example.

BV4242 Features

  • I2C Control
  • User selectable I2C address
  • Software variable back light
  • Three PWM back light outputs
  • 16 Pad touch keypad
  • 32 key buffer
  • Interrupt pin
  • Beeper output
  • Pads fully configurable
  • Mounts is standard box
  • User printable Front panel overlays
  • Wide voltage 2.5V to 5V *
  • 10.4mA @ 5V
  • 3.7mA @ 5V sleep mode
  • Only 2 wires for full I/O control

* This will largely depend on the back light that is fitted.

NOTE: Comes without the LCD display and front overlay but there are templates on line to print using an ink jet printer

 

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:



Tags: BV4242, 4242
Powered By OpenCart
ByVac © 2017 - Designed by Yoocart