BV501 flash full?

The bv501 limitation is the flash memory size - but how do you fix a flsave("") that has exceed limit and the BV501 will not reboot? All I get are some hex numbers when it is reset so I cannot clear the Flash using flclear(0).
I think I am a couple of lines too much code!!

r[06]9[df][ce][e0]T(nr[06]9[df][ce][e0]T(nr[06]9[df][ce][e0]T nr[06]9[df][ce][e0]T(nr[06]9[df][ce][e0]T nr[06]9[df][ce][e0]T nr[06]9[df][ce][e0]T(nr[06]=[df][ce][e0]P nr[06]=[df][ce][e0]T nr[06]9[df][ce][e0]P nr[06]9[df][ce][e0]P nr[06]9[df][ce][e0]T nr[06]9[df][ce][e0]T(nr[06]9[df][ce][e0]T nr[06]9[df][ce][e0]T nr[06]9[df][ce][e0]T nr[06]9[df][ce][e0]T nr[06]9[df][ce][e0]P nr[06]9[df][ce][e0]T([fe]r[06]9[df][ce][e0]T nr[06]9[df][ce][e0]T([fe]r[06]9[df][ce][e0]P nr[06]9[df][ce][e0]T nr[06]9[df][ce][e0]P nr[06]9[df][ce][e0]T(nrF=[df][ce][e0]P nr[06]9[df][ce][e0]T(nr[06]9[df][ce][e0]P nr[06]=[df][ce][e0]T([fe]r[06]9[df][ce][e0]P(nr[06]=[df][ce][e0]P nr[06]9[df][ce][e0]T(nr[06]9[df][ce][e0]T(nr[06]9[df][ce][e0]T nrF=[df][ce][e0]P nr[06]9[df][ce][e0]T nr[06]9[df][ce][e0]P nr[06]=[df][ce][e0]P nr[06]9[df][ce][e0]T([fe]r[06]9[df][ce][e0]P nr[06]9[ff]

This is what happaens on a reset!
Have changed USB - serial and checked power. 3.3v and 5v ok



Edited 1 time(s). Last edit at 06/01/2014 11:34PM by TCKsteve.

There is a flash reset that involves sending '\' within 1/2 second of a physical reset. The BvSerial can do this for you the command is .loopbreak (dot loopbreak). This should clear everything from flash, just as flclear(0) would have done.

Unfortunately I have tried "\" and now have tried .loopbreak with two seperate USB/serials.
Using .loopbreak I get:
tmp = r
- then numbers similar to above.
There is no backlight on the LCD screen/display, the Bypic firmware code is not working to give a prompt.

Seems there are no more bv501's for sale ????
I had a good working working program on this and was about to put it into a nice box...

The BV501 is short of Flash and so in design is an update that will probably use the MX3 version of the PIC32 family and also the SD Card that goes with it. Anybody who has purchased the original BV501 will not be forgotten.

There are some BV501's left if you want another, let me know by email.

(** Check your email for a fix to the above problem **)