BV4626 How do I make it work! NOW FIXED

I can "talk" to it using the terminal but can't get any response using justbasic.

Please can someone give me a couple of lines of code just to turn a relay on/off, justbasic or any other prog, then I can take it from there..

........and I thought I was damn good with basic!! Seems I have trouble getting the escape character to the unit up front.

PS. 2nd question: How can I use this with terminal using something other than the escape key to start...

Martin.



Edited 1 time(s). Last edit at 10/24/2012 08:34PM by Deadlizard.

All of the information is here:
[doc.byvac.com]
There is a zip file with a user guide and smaple VB code.

Thanks, I have all the downloads, the example seems to need VB installed, I have Just basic which I cant get to do anything with the code.
The instructions do not say what to do, just say what's there....is there an executable I should run or something?
windows 7. btw

I think you must be looking in the wrong place, the turotial is here: MX1 Tutorial
Click on the Introduction at the right hand side and build the circuit on the breadboard (as it says).

Sorry but whats that got to do with the BV4626 Module?

I sorted problem and tried to post code but format gets screwed so try again later



Edited 4 time(s). Last edit at 10/24/2012 08:41PM by Deadlizard.

Sorry,
its me looking in the wrong place. To post code there is a code icon on the toolbar above next to the quotes icon.