Thank you for you response. I need to do some more investigation. Please could you just clarify if the P0 command has been issued for no prompt or the auto baud has been turned off, does it stay like that even after a power off reset?by Peter - Serial & I2C Devices
Thank you very much for the information I suspect your diagnosis about the buffer is correct. I searched the documentation and couldn't find any reference for P1, what does this do? I managed to upgrade the firmwhere (although it's almost new so I suspect it didn't need it) and it's up and running again which is a big relief as I can carry on with my project. I have managed to lock it upby Peter - Serial & I2C Devices
I've been working with a BV4221 to read and write to a I2C device, initially using BV-Com which worked fine and I've just started writing some VB code. All was going well until I tried to write a 255 byte block of data when it all locked up. After a reset it doesn't appear to function as before. It appears as a com port but I can't get the 0x42> prompt anymore. The three chip select linesby Peter - Serial & I2C Devices